SJ500 industrial joystick

Product Features
1.Building block design
2.Spring automatic reset
3.Fully sealed design
4.Can adapt to the complex environment
Application
SJ500 industrial joystick, mainly used in forklift truck and other construction machinery hydraulic proportional control and variable frequency motor control.

Technical Specifications
Environment Specifications
Storage temperature normal temperature
Operating temperature —30℃~+80℃ hall —40℃~+80℃
Installation of flange protection grade IP64
Vibration amplitude of vibration ±3g, frequency 10HZ-200HZ
Shock 20g, 6ms, half sine type
EMC anti-interference grade 100V/m, 30MHZ-1GHZ, 80%Sine-wave modulation, satisfy EN 50082-2 (1995) standards
Transmit grade 150KHZ-30MHZ, grade B, satisfy EN 50081-2 (1993) standards
ESD anti-interference grade Level 4, 8kv contact discharge, 15kv air discharge, satisfy IEC 61000-4-2 standards 

Mechanical Specifications
Mechanical rotation ±32° (potentiometer)   ±20° (hall sensor)
Operating torque 1.5N(50Nmax)
Mechanical life 5,000,000 cycle
Mechanical tolerance ±0.5°

Electrical Parameters
 
Hall type
Power supply voltage 5±0.5VDC
The power consumption of current 6.5 mA/each hall chip
Resolution  Infiniti
Maximum voltage 15 VDC continuous
Reverse polarity maximum voltage 14.5VDC
Load resistance 5KΩ
The median voltage (no-load) 48~52%Vs
 
 
Potentiometer
Power supply voltage DC24V
Power supply current <20mA
Resolution  Infiniti
Resistance (10%) 2KΩ, 5KΩ, 10KΩ
Electrical rotation ±32°
Output voltage range (Relative voltage) 0~100%;10~90%
Maximum voltage 48%~52%
Potentiometer maximum load of voltage 32VDC
Maximum power consumption (25 ℃) 0.25W
The direction of the switch Switch position ±3°

Product Configuration
No. Project Content
1 Industrial SJ500 Industrial Joystick
2 Operation Direction  T-automatic spring return
 
 
3
 
 
Operation Direction
 
 
 
4
 
 
 
Electrical Output Form
Table SJ500-1
 
 
Hall Output
HV1:DC5V 0-2.5-5V
HV2:DC5V 0.5-2.5-4.5V
HV3:DC5V 1.0-2.5-4.0V
HV4:DC5V 1.25-2.5-3.75V
 
 
Potentiometer Output
P1:Ordinary two directions output
P11a: Ordinary double direction opposite output
P11b: Ordinary double direction same output
5 Potentiometer Type 1K,2K,5K,10K,20K,H-Hall
6 Quantity of Switch Quantity of Switch Signal 01, 02 and 03. Refer to appendix 4-3 of conventional closed form
7 Common Closed Position
8 Handle Type Standard Configuration
9 Remark Line with, special instructions, do not need not.
Table 4-3 Common Closed Position
Wiring instructions
Potentiometer output
 
Hall type voltage output
 
 

Product Installation
Triangle Handle Size

Square handle size